The electrical switch contacts open when the suction pressure drops to 152 193 kpa 22 28 psi.
2008 mustang ac low pressure switch location.
Is the low port for ac service located on the drivers side of the engine on 97 f250 extended.
I was thinking that a connector might be unplugged.
Incorrect pressure can damage the compressor hoses and other a c system components.
I was hoping to jumper the low side switch and see if that is the problem.
The low pressure switch is located on the low side line on the passenger s side left of the strut tower.
When i jump the clutch relay for the compressor it blows cold.
To access the low pressure port you have to remove the right front wheel and inner fender.
Jdm swapped the engine awhile back and never even noticed the ac was not working since i was not using it.
But with 95 degrees.
Mustang s197 forums 2005 2014 mustangs 2005 2010 v6 mustang tech.
The only port i see low answered by a verified ford mechanic.
But usually the sensors are most often located in the engine bay or under the front on the ac condenser on the front of the car.
Some vehicles are equipped with just a high pressure switch while others have both.
The location of the refrigerant pressure sensor can differ a lot between car models and depending on whether you are going to replace the high or low pressure sensor.
I am trying to find the low side port to to top off freon on my daughters 2008 v6 mustang.
There are both high pressure and low pressure switches.
A valve depressor located inside the threaded end of the a c cycling switch presses in on the schrader valve stem.
Any ideas and does anyone know the location of the high pressure switch.
Dark age 53.
Here are both high and low side pressure sensors so you can see how the system works.
Check out the diagrams below.
The low pressure service gauge port valve is located on the suction accumulator.
This allows the suction pressure inside the suction accumulator to control the operation of the a c cycling switch.
I have jumped the relay low pressure switches and still the ac blows warm air.
Where is the low pressure port for the a c located on the 1994 ford explorer xlt can the.
Check the pressure of the air conditioning system by attaching a low pressure gauge from a refrigerant recharge kit to the low pressure fitting located between the accumulator and the compressor and marked with a capital l according to aa1 car on an 80 degree day the low pressure gauge should measure 56 psi pounds per square inch or higher.
Please let us know if you need anything else to get the problem fixed.
